Skip Navigation Website Accessibility
 
 

Ronix M6 Toggle Bolt Baseless Boot Hardware

   
Quantity:    

Add to Cart

The Ronix M6 Toggle Hardware, works for Ronix bindings being mounted to wakeboards that are 2013 or newer. Any board older than a 2012 will require Standard (1/4-20) Threaded screws.

Since the hardware has a toggle that swivels, You can Tighten your bindings up on the go, without needing a screwdriver. 

`


Events

Below is where we will post our current or upcoming events. These events may be held at or put on by Pinewski's. Some may even be events in the industry that we think you should go check out. If there is nothing below, unfortunately we do not have anything to share. So if you have an event you think we would be interested in, or would like to see posted here, please do share!